Course Information
Course Overview
All Skills You Need to Pass The Exam
This course is all about CCNP ROUTE 300-101 and all the necessary skills to configure different feature in your network Cisco routers and of course pass the exam successfully.
Some of the course contents use older version of GNS3 and although there is no difference in what you see here from a newer version, you might want to skip these sections.
I have explained all commands in detail so that you can easily get a grab on that feaure. If you cannot find a feature, this means either it is obsolete and a better feature replaces that or I have forgotten to include it. In the latter case, I will be more than happy if you let me know what you want and I will add it to the curriculum.
I have used GNS3 for the simulation. However, you can execute all commands on a real gear without any change.
Course Content
- 10 section(s)
- 98 lecture(s)
- Section 1 Introduction
- Section 2 Setting Up the LAB ---OLDER VERSION OF GNS3
- Section 3 Challenges
- Section 4 IPv4 Addresses
- Section 5 Creating First Topology on GNS3
- Section 6 PPP (Point-to-Point) Links
- Section 7 Frame Relay
- Section 8 DHCP (Dynamic Host Configuration Protocol)
- Section 9 Static Routing
- Section 10 RIP (Routing Information Base)
What You’ll Learn
- Ethernet Network Challenges
- Working with IPv4 and IPv6 addresses
- Point-to-Point and Frame-Relay Links
- RIP, OSPF and EIGRP protocols in detail
- Border Gateway Protocol (BGP) in detail
- Multi-Protocol Label Swtching (MPLS) protocol + VRFLite
- Redistribution between routing protocols in detail
- Policy-Based Routing (PBR)
- Tunneling technologies for IPv4 and IPv6 protocols
- NetFlow
Skills covered in this course
Reviews
-
AAndrés Rosales Luna
Thank you. It was an amazing course.
-
GGunashekaran G
good
-
IIsmail Aden Ali
Good explanation and it is very clear.
-
KKenan Dedoviq
Nice course