HVAC​ Commissioning 2 - FAT / SAT

Let's figure out what kinds of tests shall be done during the FAT and SAT for the HVAC control system

Commissioning is one of the critical procedures for the project. It is not easy to understand because it depends on the project and end-user standards. For example, I did the performance test for the HVAC system when I worked for an EPC project in Qatar. But I didn’t do it when I handled an EPC project in UAE.

Furthermore, it is difficult for engineers who have majored mechanical engineering in their colleges to deal with automatic control systems. Generally speaking, a control panel (CP) has lots of components to check during the FAT or SAT.

These are the main reasons for me to desire to make this course. I will show you the typical FAT and SAT for the HVAC industrial projects. If you need to deal with a FAT or SAT for the HVAC projects, you can understand about it with this course. You can use this course according to the situation since I put activities as many as possible into this course to contain as much as information.

We will discuss about the below activities.

· Introduction

· AHU, ACCU & CP Appearance

· CP Painting

· CP Configuration

· CP Power Cable

· CP Power On

· I/O Point Check

· Function Test

· SAT

From this course, you will get ideas about what kinds of activities shall be done during the FAT or SAT. For your information, I have made this course according to my experiences I got while working for 4 EPC projects in Middle East.

I hope you would understand about the HVAC more with this course.

Good luck.